Connect to terraPen via USB-C¶

It is possible to control the terraPen using software such as LightBurn over USB-C. This page will outline the steps required.

• Plug in terraPen to a wall outlet
• Plug in USB-C to desktop / laptop
• Check Device Manager for available ports

• Connect to port in Lightburn

• Check serial port for connect and status

• If in alarm state, type $X to remove alarm

• The move commands move the axis incorrectly, and the penup/down does not work correctly

[!Note] The move commands move the axis incorrectly, and the penup/down does not work correctly Additional details to connect FLuidNC (the firmware terraPen utilises) with Lightburn here.